Table of Contents
Advertisement
5.2 Hardware Installation
Use the supplied USB cable to connect the GUITAR RIG MOBILE I/O directly to a USB 2.0
port on your computer.
GUITAR RIG MOBILE I/O is powered via USB. Operation is guaranteed only with USB 2.0
controller as a single device or with self-powered USB 2.0 hubs.
After successfully installing the driver, the GUITAR RIG MOBILE I/O should be recognized au-
tomatically. If at any time the computer does not seem to recognize the GUITAR RIG MOBILE
I/O, disconnect the USB cable, wait a few seconds, then re-connect it. If this does not solve
the problem, restart your computer with the interface connected.
5.3 Configuration
This chapter explains how to use the GUITAR RIG MOBILE I/O audio interface under Mac
OS X and particularly with the included GUITAR RIG 4. It is assumed that you have already
activated GUITAR RIG 4 using the Service Center – please refer to the Setup Guide for help
on this process.
GUITAR RIG MOBILE – 28
Advertisement
Table of Contents
