The Input Level Of Guitar Rig 4 - Native Instruments Guitar Rig Mobile Hardware Reference Manual

The Input Level LED helps you identify the level of the incoming signal:
LED Status
LED is off
LED flashing green
LED flashing red
Before adjusting the input sensitivity, turn up the volume knob on your guitar. Strum some
chords at the volume level you are typically playing at and monitor the Input Level LED:
1. Turn up the input level knob just until the LED starts turning red when you play.
2. At that point, slightly turn the knob down until the LED no longer turns red, even when
you are playing really powerful chords.
Now the input sensitivity is set to its optimum level, enabling the GUITAR RIG MOBILE I/O
to provide the highest dynamic range without clipping.

4.4.2 The Input Level of GUITAR RIG 4

It is assumed that your guitar is connected to the GUITAR RIG MOBILE I/O and its input level
is properly adjusted (see section 4.4.1). Now you need to make sure that the input signal is
processed at the right level by the software.
Please take a look at the header of the GUITAR RIG 4 window: It consists of the input module
with channel selectors, a basic noise gate, the output module with a limiter and information
about the processing power consumed.
Meaning
No incoming signal
Incoming signal
Incoming signal is too loud
GUITAR RIG MOBILE – 23