Battery-Charging Generator Drive - Drive Belt Replacement - MTU 8 V 2000 M40A Operating Instructions Manual

6.18.2 Battery-charging generator drive – Drive belt replacement
Preconditions
☑ Engine is stopped and starting disabled.
Preparatory steps
1. Remove limit switch (4).
2. Remove indicator (1).
3. Remove screws (3) of protective cover (2).
4. Take off protective cover.
Replacing drive belt
1. Counterhold adjustment lever (2) at square
(5) using a square socket wrench.
2. Use the square wrench to turn the adjust‐
ment lever until the drive belt (4) is re‐
leased.
3. Take off drive belt.
4. Make sure that the belt pulleys are clean.
5. Fit new drive belt.
6. Adjust belt tension (→ Page 167).
MS150031/03E 2011-10 | Task Description | 169