Loading The Film - Mamiya 7 II Instructions Manual

Loading the Film

1. Operate the spool bearing release lever.
Push the spool release lever "A" on right side to the right,
and install the take-up spool in the take-up spool chamber
"B", top first, then push the lower spool stud up.
2. Place the film in the film chamber.
Like installing the take-up spool, push the spool release
lever on left side to the left, place a roll of film in the film
chamber, making sure it seats properly. Make sure the
backing paper is in the position illustrated above, black
side facing the lens, colored side towards the back.
When the new roll has been inserted, be sure to reset
the lower spool stud by pressing it in. (Also, be sure to
reset the take-up spool stud in a similar manner.)
3. Insert the film into the groove of the spool in the
wind-up chamber.
Pull out the backing paper, and insert the tip into the slot
on the take-up spool as pictured.
17