Carrying Out The Descaling Process - Miele H6160B Operating And Installation Instructions

Cleaning and care

Carrying out the descaling process

As soon as the intake process E 0
has been started the descaling
process can no longer be
cancelled.
F Select the Moisture plus d function.
G Use the rotary selector to select E.
H Touch the OK sensor.
If the Moisture plus d function was
already locked, the descaling
process can be started immediately
by touching the OK sensor.
The prompt for the drawing in process
(E 0) will appear and the triangle V will
flash under ?.
E
?
;
I Touch the OK sensor.
The intake process will begin. You can
hear the pump while this is happening.
The amount of solution specified can
be more than the amount which is
actually taken in. Some of the solution
may therefore be left in the container at
the end of descaling.
98
The activation phase (E i) will begin.
You can follow the duration as it counts
down.
J Open the door.
K Leave the container with the tube
L Close the door.
o
The system will take in more liquid at
approximately 5 minute intervals. You
will hear the noise of the pump for a
moment or so.
The descaling step can be displayed:
^ Touch X.
^ Use the rotary selector to select 6.
^ To display time remaining, use the
At the end of the activation phase a
buzzer will sound three times, if the
buzzer is switched on (see "Settings –
P 2").
:i : 20
F
connected to the water intake pipe in
the oven. Top the container up with
approx. 300 ml of water, as the
system will need to draw in some
more liquid during the activation
phase.
E
F
rotary selector to move the triangle
V until it is under T.
h
T
i
6 T
;