Max Volume; Initial Volume; Dynamic Range - Yamaha AVENTAGE RX-A3050 Owner's Manual

• Even if "Auto/Manual Select" is set to "Auto", the automatic adjustment does not work depending on
the TV connected to the unit. In this case, adjust the delay manually in "Adjustment".
Adjustment
Adjusts the delay between video and audio output manually when "Auto/Manual
Select" is set to "Manual". You can fine-adjust the audio output timing when
"Auto/Manual Select" is set to "Auto".
Setting range
0 ms to 500 ms (1 ms increments)
• When "Auto/Manual Select" is set to "Auto", "Offset" shows the difference between automatic
adjustment and fine adjustment.
■

Dynamic Range

Selects the dynamic range adjustment method for bitstream audio (Dolby Digital and
DTS signals) playback.
Settings
Maximum Produces audio without adjusting the dynamic range.
Standard Optimizes the dynamic range for regular home use.
Sets the dynamic range for clear sound even at night or at low
volumes.
Minimum/Auto
When playing back Dolby TrueHD signals, the dynamic range is
automatically adjusted based on the input signal information.
■

Max Volume

Sets the maximum volume to prevent excessive loudness.
Setting range
-30.0 dB to +15.0 dB (5.0 dB increments), +16.5 dB
■

Initial Volume

Sets the initial volume when the receiver is turned on.
Settings
Sets the level to the volume level of the unit when it last entered
Off
standby mode.
Sets at Mute or the specified volume level (-80.0 dB to +16.5 dB,
0.5 dB increments).
On
(Specify a volume level which is lower than the "Max Volume" setting.)
■
Pure Direct Mode
Selects whether to output video signals during the Pure Direct mode (p.80).
Settings
Automatically outputs video signals when any videos are input from the
selected input source or an input source that can be operated with the
Auto
on-screen display is selected. When no video signals are input, the
wall paper is displayed.
Video Off Does not output video signals including the wall paper.
■
Adaptive DSP Level
Selects whether to automatically adjust the CINEMA DSP effect level.
Settings
Off Does not adjust the effect level automatically.
Adjusts the effect level automatically according to the YPAO
On
measurement results and the volume level.
139
En