Yamaha AVENTAGE RX-A3050 Owner's Manual page 66

1 2 3 4 5 6 7 8 9 10 11
SOURCE SOURCE RECEIVER RECEIVER
RECEIVER z
AV AV
1 1 2 2 3 3 4 4
5 5 6 6 7 7 V-AUX V-AUX
AUDIO AUDIO
1 1 2 2 3 3 PHONO PHONO
TUNER TUNER BLUETOOTH BLUETOOTH USB USB NET NET
MAIN MAIN 2 3 4 2 3 4
PARTY PARTY HDMI OUT HDMI OUT
ZONE ZONE
SCENE SCENE
1 1 2 2 3 3 4 4
PROGRAM PROGRAM MUTE MUTE VOLUME VOLUME
ON SCREEN
TOP MENU TOP MENU POP-UP/MENU POP-UP/MENU
ON
OPTION OPTION
SCREEN
Cursor keys
ENTER
ENTER
RETURN RETURN DISPLAY DISPLAY
BAND BAND
MODE MODE
TUNING TUNING PRESET PRESET
SUR. DECODE SUR. DECODE STRAIGHT STRAIGHT
MOVIE MOVIE MUSIC MUSIC
ENHANCER ENHANCER PURE DIRECT PURE DIRECT
INFO INFO SLEEP SLEEP
1 1 2 2 3 3 4 4
5 5 6 6 7 8 8
MEMORY MEMORY
10 10
9 9 0 0 ENT ENT
TV TV
INPUT INPUT
TV VOL TV VOL TV CH TV CH
MUTE MUTE CODE SET CODE SET
❑ Sharing the iOS device setting using a USB cable
If you select "USB Cable" as the connection method, follow the
procedure below to share the iOS device setting with the unit.
1
Connect the iOS device to the USB jack, and disable
the screen lock on the iOS device.
The unit (front)
ZONE 2 ZONE 3 ZONE 4
RETURN DISPLAY
PHONES VIDEO AUX
5V 1A YPAO MIC SILENT CINEMA VIDEO L AUDIO R
2
Use the cursor keys (e/r) to select "NEXT" and
press ENTER.
3
Tap "Allow" in the message appeared on the iOS
device.
When the connection process finishes, "Completed"
appears on the TV screen.
4
To exit from the menu, press ON SCREEN.
■
B: Using the WPS push button
configuration
You can easily set up a wireless connection with one push of the
WPS button.
• This configuration does not work if the security method of your wireless router
(access point) is WEP. In this case, use other connection method.
ZONE CONTROL
1
2
3
About WPS
WPS (Wi-Fi Protected Setup) is a standard established by the Wi-Fi Alliance,
which allows easy establishment of a wireless home network.
66
En
Press RECEIVER z to turn on the unit.
Hold down INFO (WPS) on the front panel for 3
seconds.
"Press WPS button on Access Point" appears on the front
display.
Push the WPS button on the wireless router (access
point).
When the connection process finishes, "Completed"
appears on the front display.
If "Not connected" appears, repeat from Step 1 or try
another connection method.