Installing The New Lamp - Proxima Desktop Projector 9100 User Manual

Multimedia lcd projector
Table of Contents

Advertisement

5 Locate the door to the lamp chamber on the right side of the left panel. It
has one slotted captive screw. With a screwdriver or coin, loosen the
screw, then open the lamp chamber door (see Figure 5-3).
Figure 5-3, Opening the lamp chamber door
6 Locate the thumbscrew on the right side of the lamp and unscrew it.
When the thumbscrew is loose enough, gently pull the lamp from the
right socket and then slide it out from the left.

Installing the new lamp

Caution! Make sure to wear gloves or use a soft cloth to handle the new
lamp. Never touch the lamp with your bare hands, as this can significantly
shorten the life of the lamp. If you do touch a portion of the lamp with your
bare hands, wipe it off with a soft cloth moistened with denatured alcohol.
To install a new lamp:
1 Remove the lamp from the package.
2 The lamp has thumbscrews on both ends. Remove the thumbscrew from
the end of the lamp that has no printing. Discard the thumbscrew.
5-4
Chapter Five

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dp9100

Table of Contents

Save Article as PDF