Stubborn Soiling On The Flexiclip Runners; Cleaning The Catalytic Enamelled Back Panel; Removing Spice, Sugar And Similar Deposits - Miele H6461B Operating And Installation Instructions

Stubborn soiling on the
FlexiClip runners
Never attempt to clean FlexiClip
telescopic runners in a dishwasher.
This would remove the special
grease which is essential for their
smooth functioning.
For stubborn surface soiling or if the
bearings become sticky with spilled
fruit juices proceed as follows:
^ Soak the FlexiClip runners for approx.
10 minutes in a solution of hot water
and washing-up liquid. If necessary
use the back of a washing-up
sponge to remove the soiling. The
bearings can be carefully cleaned
with a soft brush.
Cleaning may cause some
discolouration or fading in places,
however this will not affect the
functioning of the runners in any way.
Cleaning and care
Cleaning the catalytic
enamelled back panel
Soiling from oil and fat is burnt off
catalytic enamel when very high
temperatures are used in the oven.
The higher the temperature, the more
effective the process.
Exposure to scouring agents,
abrasive brushes or sponges and
oven sprays can cause catalytic
enamel to lose its self-cleaning
properties.
Catalytic enamelled panels should
therefore be taken out of the oven
before using oven spray in it.
Removing spice, sugar and similar
deposits
^ Remove the back panel (see
"Cleaning and care - Removing the
back panel").
^ Clean the back panel by hand with a
solution of hot water and washing-up
liquid applied with a soft brush.
^ Rinse it thoroughly and then leave it
to dry before fitting it back in the
oven.
99