Bevel Angle - Makita LS1212 Instruction Manual

1
2
3
1. Screw
2. Miter scale
3. Pointer
1
2
3
1. Arm
2. Lever
3. Hex bolt
1
1. Hex bolt
1
3
1. Triangular rule
2. Saw blade
3. Top surface of turn base
Make sure that the pointer points to 0° on the miter
002237
scale. If the pointer does not point to 0°, loosen the
screw which secures the pointer and adjust the pointer
so that it will point to 0°.

2. Bevel angle

001569
(1) 0° bevel angle
001570
001571
2
Push the carriage toward the guide fence and
tighten the knob to secure the carriage. Lower the
handle fully and lock it in the lowered position by
pushing in the stopper pin. Loosen the lever at the
rear of the tool. Make sure that the arm is locked.
Turn the hex bolt on the left side of the arm two or
three revolutions counterclockwise. Turn the hex
bolt on the right side of the arm two or three revolu-
tions counterclockwise to tilt the blade to the left.
Carefully square the side of the blade with the top
surface of the turn base using the triangular rule,
try-square, etc. by turning the hex bolt on the right
side of the arm clockwise. Turn the hex bolt on the
left side of the arm clockwise as far as it will go.
Then tighten the lever securely.
29