Download  Print this page

Compound Cutting; Cutting Crown And Cove Moldings - Makita LS1212 Instruction Manual

Slide compound saw equipped with electric blade brake 305 mm (12”)
Hide thumbs

Advertisement

Table of Contents
CAUTION:
Always be sure that the blade will move down to bevel
direction during a bevel cut. Keep hands out of path of
saw blade.
During a bevel cut, it may create a condition whereby the
piece cut off will come to rest against the side of the
blade. If the blade is raised while the blade is still
rotating, this piece may be caught by the blade, causing
fragments to be scattered which is dangerous. The blade
should be raised ONLY after the blade has come to a
complete stop.
When pressing the handle down, apply pressure parallel
to the blade. If the pressure is not parallel to the blade
during a cut, the angle of the blade might be shifted and
the precision of the cut will be impaired.
Always set the sub-fence to the left position when
performing left bevel cuts.

5. Compound cutting

Compound cutting is the process in which a bevel angle
is made at the same time in which a miter angle is being
cut on a workpiece. Compound cutting can be performed
at angle shown in the table.
Miter angle
Left and Right 45˚
Right 50˚
Right 55˚
Right 60˚
When performing compound cutting, refer to "Press cut-
ting", "Slide cutting", "Miter cutting" and "Bevel cut"
explanations.

6. Cutting crown and cove moldings

Crown and cove moldings can be cut on a compound
miter saw with the moldings laid flat on the turn base.
Bevel angle
Left and Right 0˚ - 45˚
Left 0˚ - 40˚ and Right 0˚ - 45˚
Left 0˚ - 35˚ and Right 0˚ - 45˚
Left 0˚ - 35˚ and Right 0˚ - 45˚
19

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Makita LS1212