Download  Print this page

Horizontal Vise (Optional Accessory); Holders And Holder Assembly - Makita LS1212 Instruction Manual

Slide compound saw equipped with electric blade brake 305 mm (12”)
Hide thumbs

Advertisement

Table of Contents
1
2
3
1. Vise plate
2. Base
3. Vise nut
4. Vise knob
1
2
1. Holder
2. Holder assembly
2
1. Holder assembly
2. Rod 12
16

Horizontal vise (optional accessory)

002230
The horizontal vise can be installed in two positions on either
the left or right side of the base. When performing 15° or
greater miter cuts, install the horizontal vise on the side
opposite the direction in which the turn base is to be turned.
By flipping the vise nut to the left, the vise is released, and
rapidly moves in and out. To grip the workpiece, push the
4
vise knob forward until the vise plate contacts the workpiece
and flip the vise nut to the right. Then turn the vise knob
clockwise to secure the workpiece.
The maximum width of workpiece which can be secured by
the horizontal vise is 200 mm (7 - 7/8").
When installing the horizontal vise on the right side of the
base, also use the sub-fence R to secure the workpiece
more firmly. Refer to the "Sub-fence R" section described on
previously for installing the sub-fence R.
CAUTION:
Always rotate the vise nut to the right fully when securing
the workpiece. Failure to do so may result in insufficient
securing of the workpiece. This could cause the
workpiece to be thrown, cause damage to the blade or
cause the loss of control, which can result in
PERSONAL INJURY.

Holders and holder assembly

002247
(optional accessories)
The holders and the holder assembly can be installed on
either side as a convenient means of supporting workpieces
horizontally. Install them as shown in the figure. Then tighten
the screws firmly to secure the holders and the holder
assembly.
When cutting long workpieces, use the holder-rod assembly
002246
(optional accessory). It consists of two holder assemblies
and two rods 12.
CAUTION:
Always support long workpieces level with the top
surface of the turn base for accurate cuts and to prevent
1
dangerous loss of control of the tool.

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Makita LS1212