Download  Print this page

Cutting Aluminum Extrusion - Makita LS1212 Instruction Manual

Slide compound saw equipped with electric blade brake 305 mm (12”)
Hide thumbs

Advertisement

Table of Contents
1
3
1. Crown molding stopper L
2. Crown molding stopper R
3. Base
2
1
3
1. Guide fence
2. Crown molding
3. Crown molding stopper
4. Screw
1. Vise
2. Spacer block
3. Guide fence
4. Aluminum extrusion
5. Spacer block
Crown molding stoppers (optional accessories) allow
002262
2
easier cuts of crown molding without tilting the saw
blade. Install them on the base as shown in the figures.
Position crown molding with its WALL CONTACT EDGE
001560
against the guide fence and its CEILING CONTACT
EDGE against the crown molding stoppers as shown in
4
the figure. Adjust the crown molding stoppers according
to the size of the crown molding. Tighten the screws to
secure the crown molding stoppers. Refer to the table
(C) for the miter angle. Use the sub-fence R to secure
the crown molding more firmly.
For inside
corner
For outside
corner

7. Cutting aluminum extrusion

001844
When securing aluminum extrusions, use spacer blocks
or pieces of scrap as shown in the figure to prevent
1
deformation of the aluminum. Use a cutting lubricant
2
when cutting the aluminum extrusion to prevent build-up
3
of the aluminum material on the blade.
4
5
CAUTION:
Never attempt to cut thick or round aluminum extrusions.
Thick aluminum extrusions may come loose during
operation and round aluminum extrusions cannot be
secured firmly with this tool.
Table (C)
Position
Miter angle
in Fig. A
(1)
Right 45˚
(2)
Left 45˚
(3)
(4)
Right 45˚
Finished piece
Save the right side of blade
Save the left side of blade
Save the right side of blade
Save the left side of blade
25

Hide quick links:

Advertisement

Table of Contents
loading

  Related Manuals for Makita LS1212