Variables De Configuration - M.T.H. Premier 2-4-1A Operator's Manual

Discussions de cabine —F27. Elles se produisent quand la machine est à
l'arrêt, au ralenti. Il existe plusieurs moments où les membres de l'équipe
de conduite discutent ensemble, quand la machine est à l'arrêt, au ralenti.
Presser F27 (active F27) désactive les discussions de cabine. Presser F27
encore (désactive F27) réactive les discussions de cabine. Ces sons
existent par défaut.
Variables de Configuration (CV)
Variables de Configuration utilisées sur les machines MTH PS3.0.
CV1
CV2
CV3
CV4
CV5
CV8
CV17
CV18
CV19
CV21
CV22
CV23
CV24
CV25
CV29
CV52
CV53
CV54
CV55
CV63
CV64
CV66
CV67-
CV94
CV95
CV105
CV106
CV115-
CV170
Vous trouverez ci-dessous le tableau des CV par défaut contenues dans le
DCC de MTH. Le tableau est spécifique à la machine décrite dans ce
manuel.
Short Address: 1-127 are the valid addresses
Start Voltage (CV52, bit0 must =1. This will enable PWM Mode)
Acceleration Rate (CV52, bit0 must =1. This wil l enable PWM Mode)
Deceleration Rate ((CV52, bit0 must =1. This will enable PWM Mode)
Max Voltage (CV52, bit0 must =1. This will enable PWM Mode)
MFG ID. MTH =27. Also used for various resets
High Byte of Extended Address
Low Byte of Extended Address
Consist Address (bit 7=1 on an engine will tell the engine it's
reversed in a consist)
Defines active Function F1-F8 for the active consist
Defines active functions for FL and F9-F12 for the active consist (bit
0=1 will tell an engine that you want it's FL control to operate under
the consist address – bit1-0/bit2=1 will configure the FL control for a
reversed engine in a consist)
Consist Acceleration Rate
Consist Deceleration Adjustment
Speed Table Select
Decoder Configuration
MTH PWM Mode Configuration
MTH Acceleration (1/8*sMPH/s). For example – a Value of 8 written
would give you 1sMPH/s acceleration
MTH Deceleration Rate (1/8*sMPH/s)
Factory Reset Alternate method: Send a value of 55 to CV55 on
address 55 and the model will go back to Factory Default
MTH Consist Acceleration Rate (1/8*sMPH/s)
MTH Consist Deceleration Rate (1/8*sMPH/s)
Forward Trim (CV52, bit0 must =1. This will enable PWM Mode)
Speed Table Selection (CV29 bit 4 must be set to 1 then CV25 must
be set to 0 or 1)
Reverse trim (CV52, bit0 must =1. This wi l l enable PWM Mode)
User ID #1 – General Purpose use for customer
User ID #2 – General Purpose use for customer
MTH Function Assignments – See table of supported CV's and
manual section on how to re-arrange them for further information
LOCOMOTIVE À VAPEUR MOUNTAIN 241 A PREMIER
20