Feature/Factory Resetting - M.T.H. Premier 2-4-1A Operator's Manual

1. Call up the engine's current address on your DCC handheld
2. Hit the PROG button twice to enter PoM mode
3. Hit Enter twice so the LCD displays "Adr"
4. Type in the new Short Address (1-127) that you want and hit Enter
5. The engine will give you a two whistle/horn blast responseTo change your
engine's Long Address using PoM:
1. Call up the current engine's address on your DCC handheld
2. Enter Programming on the Main on your DCC handheld
3. In this step you have to tell the MTH engine that you want it to start
looking at long addresses. You do this in CV29:
a.
b.
c.
d.
4. In the following steps you will now need to write values to CV17 and
CV18 to tell the engine what the long address should be

Feature/Factory Resetting

If all else fails and you aren't sure of something, never fear. You can always get your
engine back to a known state by either performing a Feature or Factory Reset.There are
a couple of ways to reset your MTH PS3.0-equipped engine:
Factory Resets – Clears everything – takes engine to just like it was
when you got it brand new
Bring up the CV menu on your DCC handheld
Enter "29" to edit CV29
Enter "36" to change the value of CV29 and hit Enter
The engine will give you a two whistle/horn blast response
Send a decimal 08 to CV 8 to reset everything
entirely back to factory default
Send a decimal 192 to reset everything except user
speed tables
Premier 2-4-1A Mountain Steam Locomotive
23