Maintenance; Lubricating And Greasing Instructions - M.T.H. Premier 2-4-1A Operator's Manual

Maintenance

Lubricating and Greasing Instructions

The engine should be well oiled and greased in order to run properly.
You should regularly lubricate all side rods, linkage components and pickup rollers to
prevent them from squeaking. Use light household oil and follow the lubrication points
in Fig. 15. Do not over-oil. Use only a drop or two on each pivot point.
Drawbar Screw
Figure 15: Lubrication Points on the Locomotive
Figure 16: Removing the Body
The locomotive's internal gearing was greased at the factory and should not need
additional grease until after 50 hours of operation or one year, whichever comes first. To
access the gear box and axles, do the following:
1. Turn the engine upside down.
2. Remove the Phillips screws (marked "GREASE"). One is located directly under the
front pick up roller. The other is located in the center of the drive wheels.
3. Use a grease tube dispenser to put a small amount (approx. 1-2 ml.) of lithium-based
grease into the gearbox and axles.
4. Replace the screws.
You should also grease the leading and trailing locomotive truck tongues to enhance their
ability to slide on the chassis. Follow the grease points shown on Fig. 17.
Body Mount Screws
Premier 2-4-1A Mountain Steam Locomotive
Lubricate Side Rods and Linkage (L) (Both Sides)
Lubricate Axle
Lubricate Pick Up Rollers (L)
Bushings (L)
Body Mount Screw
Pivot Screw
36