F3 Start Up / Shut Down; Sounds - M.T.H. Premier 2-4-1A Operator's Manual

the Advanced DCC Operation section of the manual if you want to dig into the full
capability of DCC.
Each engine type may have a slightly different F Function list. This depends upon
whether it's steam, diesel, or electric and whether it has smoke or not. Please refer to the
table of Default CV Values for your particular engine's F Functions.
A note about enabling/disabling F Functions in DCC - Depending upon the DCC
system you have you may need to toggle a particular F Function on then off to actually
get it to enable. Some DCC systems do this for you automatically and others allow you
to set particular F Function buttons to either be set for momentary or toggle. Please
refer to your DCC control station manufacturer's manual for more information on how
they handle F Function buttons.
Your MTH PS3.0-equipped engine's default short address is 3. So all you have to
do is power up your DCC system and call up Locomotive 3 to begin.
Start-Up/Shut-Down
F3 – Pressing this twice (toggle on then off) will start up your engine. When you apply
DCC power your MTH PS3.0-equipped engine will remain dark and quiet. Since you
likely don't want to run the engine this way, simply press F3 twice to start your engine.
The lights, sound and smoke (if equipped) will come on.
Note – You are actually able to move the engine in DCC without starting it up. Just
increasing the throttle will cause the engine to move. In order for F3 to function
correctly the engine must NOT be moving
To shut your engine down, press the F3 button twice. This will play the shut down
sounds and then turn the lights and smoke and sounds off. As long as there is DCC
power still on the track the engine can be started up again by pressing the F3 button
twice.
Bell/Whistle (Horn)
F1 – Bell. To activate the Bell press F1. To deactivate it, hit F1 again
F2 – Whistle (Horn). To activate the Whistle/Horn, press F2. To shut it off either let
off the F2 button or press and release it
PFA
F4 – PFA. PFA in MTH lingo stands for Passenger/Freight Announcements. Your
engine is pre-programmed for the appropriate type of sounds based upon the type
Premier 2-4-1A Mountain Steam Locomotive
19