Dcs Or Dcc; Smoke Deflector Installation - M.T.H. Premier 2-4-1A Operator's Manual

DCS or DCC

If you are operating with command control you must set the selector switch to DCC for
DCC operation and DCS for DCS operation. Refer to pages 17 and 18 to see and learn
about the differences.
CAUTION:
Do not apply DCS signals and DCC signals to the same track simultaneously. The signals
are not compatible, mixing the DCS and DCC signals will damage the DCS TIU unit.

Smoke Deflector Installation

The smoke deflectors are supplied in the package to prevent damage in shipping.
The smoke deflectors are marked L for the left side and R for the right side and are
easily installed with the supplied screws.
Insert the tab at the end of the support into the slot on the inner side of the smoke
deflector. Then align the holes in the base of the smoke deflector with the holes in the
running boards and insert the supplied screws from the under side of the running
board.
Figure 5
Location of screws
Premier 2-4-1A Mountain Steam Locomotive
4
DCS/DCC Switch
Figure 4:
DCS/DCC Switch
Smoke Deflectors
Figure 6