Quick Start - Basic Operation(All 3-Rail Models) - M.T.H. Blue Comet Operating Instructions Manual

QUICK START - BASIC OPERATION
The MTH Blue Comet contains state-of-the art electronics with several
built-in automatic features for incredibly realistic operation. Despite these
advanced features, the Blue Comet is easy to operate with any compatible
standard AC transformer (see the compatibility chart on page 34). All
models are equipped with an operating smoke system that should be primed
with smoke fluid before operating. Adding 15 - 20 drops of fluid through
the smoke stack should be sufficient. If you choose to not prime the units
with fluid, turn the smoke unit switch located under the trailing truck to
the OFF position. (See Figure 1) This will prevent any damage from
occurring to the smoke unit when running the engine without a primed
smoke unit. For more information see the section on page 4 on Smoke Unit
operation.
The Blue Comet model is controlled by
a ProtoSound® DCRU® electronic
reverse unit. The reverse unit operates in
the same manner that all reverse units
function by using forward, neutral and
reverse states that are entered each time
the throttle is turned on and off or by
using the transformer direction switch (if
so equipped).
The reverse unit is designed to ignore dirty track, dead spots on switches
RESET
Forward
Figure 2: ProtoSound® DCRU® Cycle Phases
inserted into the receptacle at the back of the boiler cab as seen in Figure 1.
Once the plug is inserted, the throttle on the transformer can be advanced.
You will see that only the engine's lights come on and that on ProtoSound
equipped engines, two dings from the sound system will chime followed by
the steam compressor pump sounds. The engine does not run. This is
known as the RESET state and is explained in more detail beginning on
Page 6. The ProtoSound® DCRU® will not power the motor until the
throttle is turned OFF and then ON again. At this point, the engine will
now function just like any other electronic or mechanical E-unit.
Neutral
Reverse
Neutral
MTH Blue Comet Operating Manual
Use First Hole For O-42 Operation
Use 2nd Hole For Display and 96 Inch
or larger diameter curves
Figure 1: Pluggin in the tender harness
or minor short circuits without
disrupting the engine operation,
even at slow, prototypical speeds.
Before the engine can be operated
however, the reverse unit plug that
extends out of the tender must be
3
Plug Tender Plug Into
Boiler Socket At Back Of Cab