Global Settings; Figure 27: Global Settings - D&R Lyra User Manual

Webpage

11.5 Global Settings

In the global setting screen you can make all kinds of basic settings.
Clock Source
Digital Nominal Level
Auto CUE Reset
CUE to CRM
CRM interlock
CRM Dim
CUE to CRM Dim
EQ Range
Aux Pre
Lyra Digital Mixer from D&R Phone +31 294 418014, email:

Figure 27: Global Settings

Clock source lets you choose the clock to which you want to synchronize the
Lyra. You can choose the following sources.
- 32 kHz internal
- 44.1 kHz internal
- 48 kHz internal
- Extern
- 48 kHz Cobranet
The clock frequency chosen is also the clock which is on the Word-clock OUT.
Note: If you are using Cobranet you have to select 48 kHz Cobranet
clock. If not the Cobranet input selections menu options will be
disabled.
Lets you adjust the headroom for the digital outputs. See also chapter 6.
This option resets the CUE when a channel goes on air. When this option is
enabled you need to set per channel if you want a local or a total CUE reset.
When this option is set the CUE buss will automatically be routed to the CRM
buss when the CUE is activated on a channel.
If this option is enabled you can only route one buss at a time to the CRM
buss.
You can set the amount of dimming you want on the CRM buss when pressing
the DIM button one the Control-surface. (0 to -144dB)
When activating a CUE when CUE to CRM is active, the signal level on the
CRM buss will be dimmed by the specified value (0 to -144dB).
The EQ range indicates the range that the three EQ levels can be adjusted. (0
to 18dB)
Determines if Aux signal is retrieved pre-fader or post-fader.
info@d-r.nl Page 40