HIKVISION E Series Installation Manual page 29

5-inch speed dome

Hide thumbs Also See for E Series:

Table of Contents

Installation Manual of E Series 5-inch Speed Dome

Back Box

Sticker

5. Drill a hole on the ceiling according to the drill template (supplied).

Note:

2mm of the diameter of the circle is tolerable.

6. Connect the cables.

The video cable, control wire and network cable have been connected to the corresponding

interfaces. Connect the power cable and the red LED indicator turns on when the power is on.

Note:

Please turn the power off after checking the speed dome.

7. Install the speed dome.

Steps:

(1) Loosen the two lock screws on both sides of the back box and make the locks in internal

position, as shown in the following figure:

Figure 3-17 Remove the Protective Accessory

Figure 3-18 Draw and Cut Hole on the Ceiling

Foam

Lower Dome

Table of Contents

Show Quick Links

Table of Contents