GE PSB9240DF Installation Instructions Manual page 2

Safety Information
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT-
Save these instructions for
local inspector's use.
IMPORTANT-Observe
all governing codes
and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these instructions
with your Owner's Manual for future reference.
• Skill Level- Installation of this appliance
requires basic mechanical and electrical skills.
• Completion Time - 1 Hour.
• Proper installation is the responsibility of
the installer. Product failure due to improper
installation is not covered under the warranty. See
Owner's Manual for warranty information.
IMPORTANT-Use
this oven onlyfor
its intendedpurpose.Never use the oven for
worming or heatingo room. Prolonged use ofthe
oven without properventilation con be hazardous.
A CAUTION:
For personal safety, remove house fuse or oven
circuit breaker before beginning installation to
ovoid severe or fatal shock injury.
A CAUTION:
For personal safety, the mounting surface must
be capable of supporting the cabinet load, in
addition to the added weight of the 80-pound oven
and 30-pound drawer, plus additional oven loads
of up to 50 pounds or o total weight of up to 160
pounds.
A CAUTION:
For personal safety, this product cannot be installed
in cabinet arrangements such as on
island, a peninsula or below a countertop.
CONTENTS
Design Information
Models Available ...................................................................... 2
Product Dimensions and Clearances ............................ 4
Tools and Ports Required .................................................... 4
Ports Supplied ........................................................................... 4
Electrical Tools and Ports Required ................................ 4
Advance Planning ................................................................... 4
Installation Preparation
Electrical Requirements ....................................................... 5
Install Junction Box ................................................................ 5
Preparing the Opening (installation without
on accessory storage drawer) ................................. 6-7
Preparing the Opening (installation with
an accessory storage drawer) ................................. 8-9
Installation Instructions
Step 1, Remove Packaging and Ports ........................ 10
Step 2, Route Conduit ........................................................ 11
Step 3, Install Bottom Trim .............................................. 12
Step 4, Install Mounting Screws .................................... 12
Step 5, Finalize Installation .............................................. 12
MODELS AVAILABLE
Models:
PSB9240DFWW - White
PSB9240DFBB - Block
PSB9240SFSS- Stainless Steel
Monogram Models:
ZSC2200NWW-White
ZSC2200N BB-Block
ZSC220ZNSS-Stoinless Steel
Monogram Pro Range Models:
ZSC2202NSS-Stoinless Steel
NOTE: This unit cannot be installed with on
accessory storage drawer,