Table of Contents
Advertisement
BASIC ADJUSTMENTS & CONTROLS
CONNECTING TO A POWER SOURCE
TO REDUCE THE RISK OF SHOCK OR FIRE DO NOT OPERATE THE UNIT WITH A DAMAGED POWER CORD OR PLUG.
REPLACE DAMAGED CORD OR PLUG IMMEDIATELY.
TO AVOID UNEXPECTED OR UNINTENTIONAL START-UP , MAKE SURE THAT THE POWER SWITCH IS IN THE OFF POSI-
TION BEFORE CONNECTING TO A POWER SOURCE.
Refer back to the section entitled "ELECTRICAL
REQUIREMENTS" and make sure all requirements
and grounding instructions are followed.
Once the assembly steps have been completed,
uncoil the power cord and plug the power cord into an
appropriate outlet.
When turning operations have been completed
unplug the lathe from the power source.
ON/OFF POWER SWITCH
This lathe is equipped with a main power on/off switch
located at the rear of the machine. This adds an addi-
tional level of protection to help prevent unintentional
start-up or unauthorized use of the lathe.
After plugging in the power cord, turn on the main
power switch. The spindle speed read-out will light up
and read "0".
ON/OFF POWER SWITCH WITH SAFETY KEY
B
A
The lathe is equipped with a rocker style ON/OFF
switch A located on the headstock, that is equipped
with a lock-out key B to prevent unwanted or unautho-
rized start-up.
SWITCH OFF
REAR VIEW
SPINDLE DIRECTION SWITCH
C
The spindle direction switch C allows the user to select
the forward or reverse mode.
To start the lathe, select either forward E or reverse D
mode.
Note: When the spindle direction switch is in the OFF posi-
F
tion
, the unit can not be started by pulling the ON/OFF
switch up.
F
D
E
11
Advertisement
Table of Contents
