Kenmore 11065202310 Installation Instructions Manual page 13

4. Connect remaining wires
Place hooked ends of remaining direct wire cable wires under outer
terminal block screws (hooks facing right). Squeeze hooked ends together
and tighten screws. Finally, reinsert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down screw. Now, go to "Venting
Requirements."
Optional 3owire Connection
You must verify with a qualified electrician that this grounding
method is acceptable before connecting_
wire and neutral wire
and neutral wire
Connect neutral ground wire (E) and neutral wire (white or center wire)
(C) of power supply cord or cable under center terminal block screw
(B). Tighten screw.
3. Connect remaining wires
©
Place hooked ends of remaining wires under outer terminal block
screws (hooks facing right). Tighten screws.
Remove center terminal block screw (B). Remove neutral ground wire (E)
from external ground conductor screw (A).
Connect a separate copper ground wire (G) from the external ground
conductor screw (A) to an adequate ground. Finally, reinsert tab of
terminal block cover into slot of dryer rear panel. Secure cover with
hold-down screw. Now, go to ""Venting Requirements/"
13