Kenmore 59679212012 Use & Care Manual page 8

Style 2
1. Create a service loop (minimum diameter of2 ft [61 cm]) w ith
thecopper tubing. Avoid kinks w hen c oiling t hecopper tubing.
2. Remove theplastic c apfrom water v alve inlet p ort. P lace a
compression nut a ndsleeve onthecopper tubing.
3. Insert theend ofthecopper tubing i ntothewater v alve inlet
port. S hape t ubing s lightly s o thatthetubing f eeds s traight into
theport t oavoid kinks.
4. Slide the compression nut over the sleeve and screw into the
water valve inlet port.
F-
............ A
A. Plastic water tubing
B, Sleeve
C, Compression nut
D. Copper tubing
5.
Using an adjustable wrench, hold the nut on the plastic water
line to keep it from moving. Then, with a second wrench turn
the compression nut on the copper tubing counterclockwise to
completely tighten. Do not overtighten.
........... D
ql
........... E
A. "P" clamp D, Compression nut
B, Plastic water line E, Copper tubing
C, Water valve inlet port
6. Check connection by pulling on copper tubing. Attach the
plastic water line to the refrigerator cabinet with a "P" clamp.
7. Turn on water supply to the refrigerator and check for leaks.
Correct any leaks.
Complete the Installation
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
1. Plug into a grounded 3 prong outlet.
NOTE: Allow 24 hours to produce the first batch of ice. Discard the
first three batches of ice produced. Allow 3 days to completely fill
the ice storage bin.
Graphics are included later in this section.
Remove and Replace Handles
1. Using
a
3/32" or 1/8" hex key, loosen the two setscrews located on
the side of each handle. See Graphics 1 and 2.
2. Pull the handle straight out from the door. Make sure you keep
the screws for reattaching the handles.
3. To replace the handles, reverse the directions.
Remove Doors and Hinges
Electrical Shock Hazard
Disconnect power before removing doors.
Faffure to do so can result in death or electrical shock.
IMPORTANT:
• Remove food and any adjustable door or utility bins from
doors.
• All graphics referenced in the following instructions are
included later in this section after "Final Steps."