Safety Information; Professional Installation Required; Servicing - HP ProCurve MSM317 Installation And Getting Started Manual

Introduction

Safety information

Safety information

Take note of the following safety information during installation of the MSM317:

Professional Installation Required

Warning
Prior to installing or using a controller, consult with a professional installer trained in RF
installation and knowledgeable in local regulations including building and wiring codes,
safety, channel, power, indoor/outdoor restrictions, and license requirements for the intended
country. It is the responsibility of the end user to ensure that installation and use comply with
local safety and radio regulations.
Cabling: You must use the appropriate cables, and where applicable, surge protection, for
your given region. For compliance with EN55022 Class-B emissions requirements use
shielded Ethernet cables.
Country of use: In some regions, you are prompted to select the country of use during
setup. Once the country has been set, the controller will automatically limit the available
wireless channels, ensuring compliant operation in the selected country. Entering the
incorrect country may result in illegal operation and may cause harmful interference to other
systems.
Safety: Take note of the following safety information during installation:
 Communications wires and cables which are installed in building locations shall be listed
CM type in accordance with ANSI/NFPA 70, the National Electrical Code (NEC), in
particular Section 800.179 (Communications Wires and Cables).
 Conductors and equipment shall be installed in accordance with ANSI/NFPA 70, the
National Electrical Code (NEC), in particular Section 725.133 (Installation of Conductors
and Equipment in Cables, Compartments, Cable Trays, Enclosures, Manholes, Outlet
Boxes, Device Boxes, and Raceways for Class 2 and Class 3 Circuits).
 Wiring methods and materials shall be in accordance with NFPA 70, the National
Electrical Code (NEC), in particular Section 725.130.
 The MSM317 does not have a power switch. It is powered-on when the Uplink port is
plugged into a PoE power source.
 The MSM317 and all interconnected equipment must be installed indoors within the same
building (except for outdoor models / antennas), including all PoE-powered network
connections as described by Environment A of the IEEE 802.3af standard.
 It is normal for the rear metal cover of the MSM317 to get hot during operation. The cover
is a heat sink and is used to dissipate the heat generated by the MSM317.

Servicing

There are no user-serviceable parts inside HP ProCurve products. Any servicing, adjustment,
maintenance, or repair must be performed only by trained service personnel.
1-8