Connectivity Page - HP ProCurve MSM317 Installation And Getting Started Manual

Connectivity page

Use the Connectivity page to define addressing settings for the Uplink port.
Enable provisioning of Connectivity here.
Interface
Set the VLAN ID that will be used on the Uplink port for management traffic. This VLAN is
only used for the discovery of an MSM7xx Controller and does not apply to user traffic sent
on Ports 1 to 4 or the Uplink port. To apply a VLAN to a port for user traffic, see
page 3-15.
Assign IP address via
Select how the MSM317 will obtain an IP address for the Uplink port.
 DHCP client: Enable this option to have the Uplink port act as a DHCP client and
request an IP address from a DHCP server. The MSM317 sends DHCP requests on the
specified VLAN if defined. If no VLAN is defined, the request is sent untagged.
 Static: Select this option to manually assign an IP address to the Uplink port.
Static IP settings
When you select Static for Assign IP address via, configure addressing settings as follows:
 IP address: Specify the IP address that you want to assign to the Uplink port.
 Address mask: Specify the appropriate subnet mask for the IP address you specified.
 Default gateway: Specify the IP address of the default gateway.
Configuration
Provisioning the MSM317
VLAN on
3-5