HP ProCurve MSM317 Installation And Getting Started Manual page 22

Installation
Hardware overview
The status lights provide the following information while the MSM317 attempts to discover
and establish a management tunnel with an MSM7xx Controller. See Working with
Controlled APs in the MSM7xx Controllers Management and Configuration Guide for more
information about the discovery process.
Behavior
Power light blinks once every two
seconds.
Power light blinks once per second.
Power, Uplink, and P2 lights blink in
sequence, from bottom to top.
Power light is On. Uplink and P2 lights
blink alternately.
Power and Uplink lights blink
alternately and quickly. P2 light is off.
Power and Uplink lights blink slowly.
Once the discovery process is complete, and the MSM317 has established a secure
management tunnel to a MSM7xx Controller, the lights provide the following information:
Light
P1, P2, P3, P4,
Uplink
PSE
Power
Wi-Fi
2-4
State Description
On Ethernet link is established.
Off Port is not connected.
Blinking Port is sending or receiving data.
On PoE is enabled on Port 1.
Off PoE is disabled on Port 1.
On The MSM317 is powered on.
Blinking The radio is transmitting or receiving data.
Description
The MSM317 is starting up.
The MSM317 is looking for an IP address, or
building the list of VLANs on which to perform
discovery. (To enable local provisioning, the
provisioning tool Login page is available until
discovery occurs. See Directly provisioning
the MSM317 on page 3-3.)
The MSM317 has obtained an IP address and is
attempting to discover an MSM7xx Controller.
The MSM317 has found an MSM7xx Controller
and is attempting to establish a management
tunnel with it.
The MSM317 has received a discovery reply
from two or more MSM7xx Controllers with
the same priority setting. The MSM317 is
unable to connect with either controller until
the priority conflict is resolved.
The MSM317 is attempting to establish an
Ethernet connection on the Uplink port.