System Set Up - Ultra Power UP300AC Touch Instruction Manual

SYSTEM SET UP

You can change SYSTEM SETTING, SAFETY OPTION settings when you enter
to setting program by touch "SYSTEM".
ITEM SELECTION
INPUT LOW
REST TIME 1-120 min
LCD LIGHT 1-10
KEY BEEP
ON/OFF
BUZZER
ON/OFF
RESET
SYSTEM
ABOUT
INPUT LOW
REST TIME
LCD LIGHT
SAFETY
OPTION
DESCRIPTION
If this charger is powerd by vehicle battery, this setting is to
protect the vehicle battery from over-discharged. UP300AC
Touch will monitor input voltage during charging. When the
input DC voltage is lower than the voltage level you set here,
UP300AC Touch will stop charging and the beep will work to
alert user.
The battery is on the cyclic process of charge and discharge
can often become warm after charge or discharge period. The
program can insert a time delay to occur after each charge
and discharge process to allow the battery adequate time to
cool down before being subjected to the next process.
The brightness of the LCD can be adjusted basing on
personal preference.
The beep sounds at every time touching the screen to confirm
your action. The beep or melody sounded at various times
during operation to alert different mode changes.
When touching "RESET SYSTEM" the charger will restore
factory default settings.
System information: model no., hardware version,
software version.
18
SYSTEM
11.0V
10min
KEY
8 ON
RESET
ABOUT
SYSTEM
BUZZER
ON
BACK