Ultra Power UP300AC Touch Instruction Manual page 13

LITHIUM BATTERY CONNECTION DIAGRAM
1. Connect charge leads to the charger, making sure polarity of all
leads is correct.
2. Turn the charger on and check your settings that they match the
battery pack you intend to charge.
3. Connect the main leads of the battery to the main leads of the
charger.
4. Connect the balance lead of the battery to the correct balance port
on the multi balance board. If in doubt as to which socket to use please
ask your dealer for clarication.
5. Start the charge cycle, wait and watch that the charger starts to
charge and shows correct readings on the screen.
6. When charging is nished disconnect the balance lead from the
board, then disconnect the battery main leads from the charging lead.
This diagram shows the correct way to connect your battery to the
UP300AC Touch while charging in the balance charge program mode
only.
WARNING:
Failure to connect will damage this charger.
11