Ultra Power UP300AC Touch Instruction Manual page 17

OPERATION DIAGRAM - SETTING, START, STOP
If you want change termination voltage level, please touch "MORE" to go to
termination voltage level setting page.
ITEM SELECTION
TERMINAL
LiPo
VOLTAGE
Lilon
CONTROL
(TVC)*
LiFe
LiPo
Lilon
LiFe
END VOLT
DISCHARGE NiMH
NiCd
Pb
WARNING! By setting the TVC to any POSITIVE SETTING above default value, you ACCEPT
ALL RESPONSIBILITY for DAMAGE to your battery, FIRE, INJURY, and any other loss which
may result. If you do not agree to accept all risk, DO NOT OPERATE YOUR CHARGER
UNLESS ALL TVC POSITIONS ARE SET TO DEFAULT VALUE!
This is the voltage level that UP300AC Touch will stop
4.18-4.3V/Cell
charging the battery.
4.08-4.2V/Cell
Intended ONLY for expert users and racers, completely at
their own risk, which allows LIPO and LIFE packs to be
3.58-3.7V/Cell
charged in excess of recommended cell terminal voltages.
3.0-3.3V/Cell
2.9-3.2V/Cell
This is the voltage level that UP300AC Touch will stop
2.6-2.9V/Cell
discharging the battery, and is shown as volts PER CELL in
0.1-1.1V/Cell
the pack (not total pack voltage).
0.1-1.1V/Cell
1.8V/Cell
DESCRIPTION
15