Table of Contents
Advertisement
Using Sony Planning
Metadata Add-in
This section describes how to use the included Sony
Planning Metadata Add-in to create and send planning
metadata.
Notes
• Configure Microsoft Outlook to send and receive email.
• Make the following settings on the 028 FILE NAMING
page of the OPERATION menu.
NAMING FORM: FREE
AUTO NAMING: PLAN
The procedure above illustrates the use of the PDW-700.
For procedures for other camcorders, refer to the
OPEARTION MANUAL or Operating Instructions
supplied with each camcorder.
See the CBK-WA01 Mounting Instructions for installation
instructions and system requirements.
Sony Planning Metadata Operation Screen
The figure below shows an example operation screen of
Sony Planning Metadata.
Displaying Planning Metadata
When you start Microsoft Outlook on the computer on
which you installed Sony Planning Metadata Add-in, a
[Sony Planning Metadata] folder is added to the [Tasks]
window.
Click the [Sony Planning Metadata] folder to display the
Sony Planning Metadata operation screen (see page 15)
appears.
To use the [Sony Planning Metadata] folder for
the first time
When you start Microsoft Outlook after installing Sony
Planning Metadata Add-in, the message in the figure
below appears.
Perform the procedure below to set the working format to
"IPM.Task.Planning Task".
1
Right click on the [Sony Planning Metadata] folder,
and then click [Properties] to open the [Sony Planning
Metadata Properties] dialog.
2
Select [IPM.Task.Planning Task] in the [When
posting to this folder, use:] list, and then click [OK].
Using Sony Planning Metadata Add-in
15
Advertisement
Table of Contents
