Using A Wireless Lan Access Point (Infrastructure Mode); Setting Up The Wireless Lan Access Point; Find And Connect To A Wireless Lan From Your Camcorder; Connecting Via Wps - Sony CBK-WA01 Operating Instructions Manual

Using a Wireless LAN
Access Point
(Infrastructure Mode)
To connect your camcorder to a LAN via a wireless LAN
access point, find the LAN to connect to on the
camcorder's menu, or perform Wi-Fi Protected Setup
(WPS).
To perform IEEE 802.1x authentication
Use the Web menu to connect to a LAN with IEEE 802.1x
authentication configured (see page 14).
Note
The procedure above illustrates the use of the PDW-700.
For procedures for using other camcorders to make Wi-Fi
connections, refer to the OPEARTION MANUAL or
Operating Instructions supplied with each camcorder.
Setting up the Wireless LAN Access
Point
The following settings are required.
Item Setting
Network ID (SSID) Example: WF_net
Encryption method Example: WEP
Network key Set to a string of 5 or 13 ASCII
characters or a string of 10 or 26
hexadecimal digits.
For details about setting up the wireless LAN access point,
see the manual of the wireless LAN access point.
Find and Connect to a Wireless LAN
from Your Camcorder
Perform steps 2 onward in "Starting a Connection" (page
8), but instead of selecting the connection network (WF1),
set the wireless LAN (WF_net), enter the network key you
configured for your access point, and make the connection.
If the camcorder is connected to the computer via a LAN
cable, you can use the Web menu to find the access point
(see page 13).

Connecting via WPS

Notes
• Make sure that your access point supports WPS.
• The procedure below illustrates the use of the PDW-700.
The menu numbers may be different for other camcorder
models.
For details about the menu operations of the PDW-700,
refer to the OPEARTION MANUAL supplied with the
PDW-700.
See your access point's manual for details about operating
your access point.
To select WPS mode
Set WPS MODE on the M25 WPS page of the
MAINTENANCE menu.
To use push method: ONE PUSH
To enter a PIN code: PIN CODE
If you select "PIN CODE", the camcorder's PIN code
appears.
PIN code
To use push method
1
Select WPS START: EXEC, and then press the
MENU knob.
"EXECUTE OK?" appears.
2
Select "YES", and then press the MENU knob, and
perform WPS on the access point.

Using a Wireless LAN Access Point (Infrastructure Mode)

11