Table of Contents
Advertisement
When the connection is complete, the WPS STATUS
display changes to "OK".
To enter a PIN code
1
Enter the PIN code displayed when you selected "PIN
CODE" on the access point.
2
Select WPS START: EXEC, and then press the
MENU knob.
The P00 ACCESS PNT page appears, and the
camcorder starts scanning for an access point.
3
When access points are detected, select the network to
connect.
When the connection is complete, the WPS STATUS
display changes to "OK".
12
Using the Web Menu (For PDW-700/F800 Only)
Using the Web Menu (For
PDW-700/F800 Only)
If the camcorder is connected to the computer by Ethernet
(for PDW-700/F800 only), you can use the Web menu to
make a Wi-Fi connection between your camcorder and
computer.
See your camcorder's operation manual for details about
Ethernet connection.
Displaying the Web Menu
1
Connect the camcorder to the computer via a LAN
cable.
2
Launch a web browse on the computer, and navigate to
"http://<camcorder's IP address>/".
Example: when the IP address is "192.168.1.10"
Type "http://192.168.1.10/" in the address bar.
If the connection is complete, a dialog appears asking
you to enter the user name and password.
3
Fill in the [User name] and [Password] boxes, and
click [OK].
Use name:
Password:
Pages in the Web Menu
Use the Network page and Wi-Fi page for Wi-Fi
connection.
Network page
Click Maintenance >Network in the Web menu to display
the Network page.
You can check or change the camcorder's IP address on
the Network page.
admin
Type the model name in
lower-case letters.
Advertisement
Table of Contents
