Installing Or Removing Bull Point Or Other Bits; Swivel Handle - Makita HM1301 Instruction Manual

0
Installing or removing'hull point or other bits (cold chisel, etc.)
CAUTION :
Always be sure that the tool
i s
switched off and unplugged before installing or remov-
ing the bit.
Pull out and turn the tool retainer so that
the boss on the tool retainer faces in the
direction of the arrow. Insert the bit into
the tool holder
as
far
as it
will go. Then
turn the tool retainer 180 degrees to
secure the bit.
To remove the bit, follow the installation
procedure in reverse.
0
Swivel handle
The easy-grip handle swivels a full
360".
This makes the demolition hammer ex-
tremely handy for all kinds of operation.
Fig. 1
Fig.
:
I
Fig. 3
5