Monitor (Voice Surveillance); Storage - Xexun TK102 User Manual

Gsm/gprs/gps tracker

Hide thumbs Also See for TK102:

Table of Contents

5.9.2 Unlimited times auto track: Send SMS "#fix#030s#***n#password#" to the tracker

device, it will reply the Geo-info continuously at 30 seconds intervals.

5.9.3 Cancellation: Send SMS "#nofix#password#" to the tracker device.

Note: the interval must not less than 20s.

5.10 Monitor (Voice Surveillance)

5.10.1 The command to switch between Track and Monitor are "tracker" and " monitor".

5.10.2 The default mode is "track" (Tracking status).

5.10.3 Send SMS "#monitor#password#" to the unit, and it will reply "monitor ok!" and switch

to "monitor" mode.

5.10.4 Send SMS "#tracker#password#" to the unit, it will reply "tracker ok!" and restore to

"track" mode.

5.11.1 Auto Storage：When the tracker devices lost GSM signals or fall offline from GPRS,

tracker will store the tracking position and alerts automatically in the flash upon the pre-set

condition, when GSM signals get back, all the event alerts will be auto-sent to the authorized

numbers or monitoring platform (server), but the stored tracking data should be loaded to the

monitoring platform via SMS command.

5.11.2: Storage Clearance: send SMS: "#clear#password#" to tracker device, it will reply "clear

ok".

5.11.3：Storage Volume: Built-in flash 1MB (store about 7,000 positions datas); external TF

card support 16 GB at most.

5.11.4 The stored data will be sent to the tracking system

www.gps103com

through the GSM

signal recover, and can check the history data on it.

Table of Contents