Connecting The Dec 3000 Model 500S Axp Server; Steps To Install Your Dec 3000 Model 500S Axp Server - DEC 3000 500 Owner's Manual

Task Overview
Table 4–1 Steps to Install Your DEC 3000 Model 500S AXP
Step
1
2
3
4
Step
5

Connecting the DEC 3000 Model 500S AXP Server

Step 1: Attach Attach the Ethernet loopback connector to the AUI Ethernet port
on the system unit, as shown in Figure 4–2. If you are planning
the Ethernet
to connect to an AUI Ethernet network or a ThinWire Ethernet
Loopback
Connector network using a DECXM transceiver (or a DESTA unit), you
may omit this step. After you have completed the connections
in this chapter, see Chapter 5 for information about network
connections.
4–4 Installing a Server System
Server
Connect the...
Ethernet loopback connector
Terminal cable (optional)
System power cord
Power cord
Check the...
Alternate console switch to
make sure it is in the correct
position
To the...
AUI Ethernet port
Alternate console/printer port
System power socket
Appropriate outlet
On the...
Rear of the system unit