Technical Specifications; Assembly Instructions - Bionaire BCH9212-CN Instruction Leaflet

A S S E M B LY I N S T R U C T I O N S
23. WARNING: This heater is not equipped with a device to
control the room temperature. Do not use this heater in
small rooms when they are occupied by persons not
capable of leaving the room on their own, unless
constant supervision is provided.
SAVE THESE INSTRUCTIONS

TECHNICAL SPECIFICATIONS

• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz
NOTE: Low Heat setting may be 1000W on some models.

ASSEMBLY INSTRUCTIONS

NOTE: A Phillips screwdriver is required for assembly.
Unpack your heater from the box, being careful to remove
all parts from plastic bags and remaining packaging. Please
save the carton for off-season storage.
Some models are packed with separate base and pedestal in
the box. Carefully remove all parts from plastic bags. To
prevent scratches, place all parts onto a cloth before assembly.
Follow the below instructions for Pedestal/Base assembly:
Pedestal Assembly (if no pedestal is included in this
model, move to Base Assembly)
Step 1: Run the power cord through the center of the
assembled pedestal. Snap pedestal into the
bottom of the heater housing. Refer to Figure 1, 2.
Base Assembly
Step 1: If the base is in two halves, snap them together
by sliding slots of one base half into slots of
second base half. Refer to Figure 3.
Step 2: Run the power cord through the center of the
assembled base. To assemble the base to the unit
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5