F E At U R E S - O P E R At I O N S; Technical Specifications; Remote Control; Operating Instructions - Bionaire BRH6403ERE-CN Instruction Leaflet

F E AT U R E S - O P E R AT I O N S

SAVE THESE
INSTRUCTIONS

TECHNICAL SPECIFICATIONS

• Amps: 8.3
• Wattage: 1000W (+5% -10%)
• Working Voltage: 120V AC/60 Hz

REMOTE CONTROL

Your heater comes with a remote control, unpack the
remote control from box. This unit requires 2 AAA
batteries, 1.5V (not included). Please note this remote
control will not work through walls. Remove battery
before discarding the remote.
Battery Replacement
a) Remove battery cover from remote control.
b) Remove old batteries from the remote control.
c) Insert two new batteries, pressing them firmly into
their slot.
d) Replace the battery cover.
NOTES:
• Replace all batteries of a set at the same time.
• Being careful not to bend or damage the contact
spring, clean the battery contacts and devices'
contacts prior to installing the batteries.
• Remove the batteries from the equipment when it is
not being used for an extended period of time.
• Remove the used batteries promptly.
• Do not mix old and new batteries. Do not mix
alkaline, standard (carbon-zinc), or rechargeable
batteries.
• Do not discard used batteries into household trash
containers. Contact your local government for
disposal or recycling practices in your area.
This Class B digital apparatus complies with Canadian
ICES-003.

OPERATING INSTRUCTIONS

NOTE: This unit is for FLOOR USE ONLY.
1. Carefully remove your heater from the box. Please
save the carton for off-season storage.
2. Make sure the unit is OFF before plugging the heater
into the outlet.
3. Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1000
Watts, this unit draws 8.3 Amps.
4. Plug the heater into a 120V AC electrical outlet. Once
plugged in, the Power Light will illuminate.
5. Press the Power Button ( ) on the control panel or
remote control to start operation. The heater will run
at default setting with 5 temperature indicator lights
and the Power Light illuminated.
Heat & $ave setting
TM
Press the Power Button ( ) to activate the
Heat & $ave™ setting. The heater will now cycle between
high and low temperatures to provide heat.
To shut off the heater, press the Power Button ( ) again
until all temperature lights are off.
NOTE: The Power Light will remain illuminated while unit
is plugged in.
Thermostat Control
Your heater is equipped with a digital thermostat that
allows you to set your heater to a precise comfort level
(18°C-30°C) by pressing either Up ( ) or Down ( )
button to activate the digital thermostat mode. Press the
Up/Down buttons on the control panel or remote control
to select your desired temperature level. The higher
temperature is selected, the more temperature indicator
lights will illuminate. When you continuously press the Up
button, all temperature lights will illuminate to indicate the
maximum temperature (30°C) is selected. When the
preset temperature is reached, the heater will cool down
by blowing cool air for 60 seconds, the power light will
flash during the cool down period, and then the heater will
shut off. When the room temperature drops below the
preset temperature, the heater will automatically turn on
again to maintain the preset temperature level.
NOTE: It is normal for the heater to cycle ON and OFF as
it maintains the preset temperature. To prevent the unit
from cycling, you need to change the thermostat setting.