Subboost; Loudness; Balance; Name - AVM inspiration C6m Operating Instructions Manual

4.13 SubBoost

If You use small speakers You can switch bass boost "on" to enhance the reproduction of low frequency
range. Subsonic frequencies will be suppressed in order not to damage the speakers.

4.14 Loudness

If You listen to music at low levels, You often recognize that bass and treble reproduction are weak. This is
because the human ear is not sensitive to bass and treble at low sound levels. To compensate this You can
use the parametric loudness function of the C6m. This function will increase bass and treble levels when You
decrease the volume. When the volume is increased the frequency response will be more and more flat and
remain linear at high volume levels. In order to obtain best results You have to proceed in the following way:
Set the amplifier to a moderate volume level. Using the buttons VALUE (7, 8) choose in the loudness
menu a curve ( 0 to 7) which gives best sound impression and exit the menu (button EXIT (6)).
NOTE: The loudness function selects automatically the correct curve depending on actual volume setting. So
if You change volume a different curve than previously selected may be shown in the loudness menu. This is
not a malfunction.

4.15 Balance

Set the balance between right and left channel for optimal stereo image.

4.16 Name

You can individually set the names (max. 8 characters) of the different sources shown in the display (3).
Enter the "NAME" menu and press one of the buttons VALUE (7, 8). Now You are in the edit mode. The
source is selected using the program selector (16). The actual character-position can be selected using the
buttons POS (4, 5). The marked character (underlined) can be changed using the buttons VALUE
(7, 8).
When You are ready, simply press EXIT (6). and the new names are stored.

4.17 Display

Sets the display brightness between 1 and 8.
NOTE: Brightness levels over 5 can lead to a burn in of the display. Therefore we recommend that the unit
shall not be operated permanently (more than 2 hours a day) with brightness levels over 5.

4.18 Processor

Switches processor function "on" / "off". If the processor is activated, it influences the signals on the speaker
outputs. The signals on record out are not affected.

4.19 Monitor

Switches tape monitor function "on" / "off". If the monitor is activated, the display (3) shows a tape symbol.
NOTE: The C6m has an "intelligent" monitor function. If the tape input is selected as source the monitor
function is cancelled to avoid feedback from the tape recorder.
To access the monitor function quickly, press the MENU button (6) and then the button PARM. (4). Now
You can switch the monitor function on and off using the buttons VALUE (7, 8).
13