Installation And Cooling; Connection To Mains; Connecting Analogue Sources; Connecting A Tape Recorder - AVM inspiration C6m Operating Instructions Manual

2.1 Installation and cooling

The inspiration C6m can become hot depending on demanded output power and environmental
temperature. Therefore it is important, that the cooling air can flow unhinderedly into the air inlet in the
bottom and flow out through the holes in the rear panel.
Additionally direct exposure to sunlight is not recommended because this will heat up the unit.

2.2 Connection to mains

Connect the amplifier to the mains outlet by using the power cord which is (in some countries) delivered
together with the unit. Make sure that mains voltage is according to the value printed on the rear panel of the
amp (near mains connector).
Let the unit be switched off until all audio connections are made.
2.3 Connecting the analogue signal sources
Connect the outputs of Your additional signal sources to the inputs (21). The upper row is for left channel,
the lower row is for right channel. The inputs tape (22) and processor (24) provide special functions, which
are described below.

2.4 Connecting a tape recorder

Connect the recorder's output to the inputs tape in (22). The inputs of the recorder must be connected to the
outputs tape out (23).
2.5 Connecting processors / equalizers
Connect the processor's output to the inputs proc in (24). The inputs of the processor must be connected to
the outputs proc out (25).

2.6 Connecting digital equipment

Connect the outputs of Your digital sources to the inputs dig in (28). The inputs of digital recorders must be
connected to the outputs dig out (27). The signal on the digital outputs depends the selected source (build in
CD, dig in 1 or dig in 2).
2.7 Connecting the loudspeakers
Connect the speakers to the speaker terminals (26). Use only good speaker cables with sufficient diameter.
Make sure, that the red terminals are connected to the red or " + " terminals of the speakers and the black
terminals to the black or " – " terminals of the speakers.
2.8 Tuner antenna
Connect the Antenna cable to the antenna socket (FM: 20 / DAB: 20a) of the C6m.
NOTE: DAB is not available everywhere. For more information please contact your local radio station.
8