Matrix U7XE-03 Service Manual page 57

CHAPTER 9: PART REPLACEMENT GUIDE
9.17 PULLEY AXLE SET REPLACEMENT - CONTINUED
5) Remove the C-clip holding the bearing in place on the right side of the frame (Figure D).
6) Remove the bearing (Figure E).
FIGURE D FIGURE E
7) Remove the 60 mm nut holding in the pulley axle assembly with a large channel lock pliers or a pipe wrench (Figure F).
8) Once the 60 mm nut is removed, the pulley axle set can be removed from the left side of the frame (Figure G).
FIGURE F FIGURE G
9) Reverse Steps 1-8 to install a new pulley axle set.
10) Test the bike for function as outlined in Section 9.21.
54