Winnebago Via 25Q Manual page 76

SECTION 7 –
PLUMBING
Pressure-Temperature Relief Valve
(Lift handle only when water heater is cold)
8. Connect Air Pressure. After water has
stopped draining at all faucets and drain
valves, leave faucets open and connect a
"blow-out" plug to the city water connection
on the coach. Then use a compressed air hose
regulated to 30 psi or less to force air through
the system. A "blow-out" plug can be
purchased at any Winnebago
dealer.
City Water
Connection
Blow-out
Fresh Water
Inlet
NOTICE
Limit air pressure to 30 psi to avoid
damage to equipment.
NOTE: DO NOT burst air into the system. This
can damage the water pump. It is better
to let air in slowly.
9. Let air flow for five minutes until water is
completely drained out of faucets and drain
valves. Then close faucets one at a time.
10. Drain Toilet. Operate and hold toilet flush
lever until water is completely drained from
toilet.
7-14
® ®
or Itasca
Air Hose
Plug
11. Turn air pressure off. Disconnect water
purge adapters. Recap the city water inlet to
avoid contamination by dirt or insects.
After Disconnecting Air Pressure
12. Close all waterline drain valves, tank drain
valves, and all faucets to avoid contamination
by dirt, insects, or rodents.
13. Reinstall the water heater drain plug and close
the Pressure-Temperature Relief valve.
14. Pour about one cup of RV antifreeze down
each drain for the galley sink, lavatory sink,
and shower/tub. This fills the drain trap pipes
to prevent holding tank odors from entering
the coach during storage.
NOTE: It is not necessary to add antifreeze to
the toilet since the flush valve will be
closed.
Do not add automotive antifreeze or
caustic chemicals such as bleach or
laundry detergents into the toilet bowl or
holding tanks. Although these products
may have a deodorizing effect, they may
damage plastic and rubber parts in the
system.
15. Empty the water pump strainer filter bowl to
avoid water freezing and cracking the filter
bowl. See "Water Pump" previously in this
section.
Dump and Clean Holding Tanks
16. Completely drain the waste water holding
tanks at an approved waste disposal site.
Drain the sewage tank first so the following
waste water can rinse any waste solids from
the dump outlet and sewage drain hose.
17. Close dump valves and refit the dust cap onto
the drain outlet.
This will inhibit rust formation on valve shafts
and prevent entry and contamination by
airborne debris, insects, and rodents.
Your drainage and fresh water systems are
now winterized.
See instructions for removal from storage in
Section 11 - Maintenance and Storage.