Client Configuration - Teltonika RUT104 User Manual

4.7.1.2

Client configuration

Enable. Check box to enable the OpenVPN.
Tun/Tap. Select tunneled or bridged connection.
Protocol. Select UDP or TCP protocol.
Port. Set the OpenVPN port. Default port 1194.
LZO. Check box to enable the LZO compression. Default: disabled.
Debug level. Select the connection debugging level. Default: 5.
Authentication. Choose the authentication type "Static key" or "Tls".
Remote host IP address. Specify the remote device (OpenVPN server) IP address.
Resolve Retry. Connection retry count. Default: infinite.
Local tunnel endpoint IP. Specify the IP address of the local VPN tunnel endpoint.
Remote tunnel endpoint IP. Specify the IP address of remote VPN tunnel endpoint.
Remote network IP address. Specify the remote network IP address.
Remote network netmask. Specify the remote network subnet mask.
Static pre-shared key. Static key configurations offer the simplest setup, and are ideal for
point-to-point VPNs. The GUI allows to upload the static key.
Important! The same key must be uploaded in server and client, e.g. if the key was generated in server,
then it must be download by clicking Download , then uploaded in the remote client VPN
configuration.
Figure 19. Client configuration
22 | P a g e