Installation; Inserting Batteries In The Remote - Memorex MLT4352 Owner's Manual

Inserting Batteries in the Remote

1
Remove the Battery Compartment
cover by pushing in on the tab and
then lifting the cover off.
2
Install two "AAA" batteries, paying
attention to the polarity diagram in
the battery compartment.
3
Replace the Battery Compartment
cover.
BATTERY PRECAUTIONS:
Follow these precautions when using batteries in this device:
1. Warning – Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment.
A reversed battery may cause damage to the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc) or old
batteries with fresh ones.
5. If the device is not to be used for a long period of time, remove the batteries to prevent damage or injury
from possible battery leakage.
6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery
manufacturer's directions.)
7. Remove batteries promptly if consumed.
8. Clean the battery contacts prior to battery installation.

INSTALLATION

- 9 -