Vga Connection - Memorex MLT4352 Owner's Manual

VGA Connection

Connect a computer to this TV as follows:
1
Make sure the power is off on the TV and computer.
2
Connect a VGA cable (not included) from the computer's VGA Out jack to the VGA
jack on the rear of the TV. Connect an audio cable (not included) from the Audio out
mini jack on the computer to the mini Audio In jack on the rear of the TV.
3
Turn on the TV and computer.
4
Press the SOURCE button and then select PC using the Navigation q/p buttons.
Confirm by pressing the OK button.
NOTES:
• For the best results, please set your PC resolution to 1360x768 at 60 Hz.
• Refer to the PC or graphic card's manual for further instructions on how to set your resolution and refresh rate.
• The VGA port of the TV features a power saving mode which will automatically turn off the TV if there's no signal provided
for more than five minutes.
INSTALLATION
RGB OUT (PC)
- 16 -
Computer
AUDIO OUT
(Not
Included)