Installing with the Stand
It is highly recommended that two people take part in removing the TV from the packaging
and installation. The TV can be installed in two ways:
• On a flat surface, using the included stand - See below.
• On a wall, using a VESA-standard wall mount (not included) - See the following page.
The included stand is designed to
support the weight of the TV and
keep it from falling over. However,
the TV can still fall over if: a) placed
on an uneven, unstable, or non-level
surface, or b) pushed, pulled, or
improperly moved. Also, make sure
to give proper clearance as shown in
the image.
1
Place TV flat on table.
2
Install base on the rear of the TV
bottom as shown in ther arrow.
3
Place the stand so the top of
the oval raised stand on base
V corner and the oval of the
bottom of the TV's back cover
are aligned, then tightly insert the
screws (see figure to make sure it
is installed properly).
4
Insert the AC plug (with the 3
blades) into a conveniently located
AC outlet having 120V, 60Hz.
INSTALLATION
4 in
- 10 -
12 in
4 in
Keep clear for air circulation
Wall
3 in
Base
Screws