Baffl E Removal & Installation - Quadra-Fire YOSEMITE-MBK Owner's Manual

E. Baffl e Removal & Installation
1. Remove all ash from fi rebox, and extinguish all hot embers
before disposal into a metal container.
2. Remove ceramic blanket and baffl e together.
3. With a 3/16" Allen wrench, remove the front manifold tube
retainer bolts on the air channel under the end of the front
tube. Figure 33.1.
NOTE: Soak the bolts with penetrating oil for at least 15
minutes before trying to remove it.
4. To remove manifold tube, slide the tube to one side until one
end is out of its hole. Then, while lifting that end of the fi ber
board baffl e, pull tube up over the air channel and out of hole
at the other end.
5. Slide fi ber board baffl e forward to front of stove and straight
out through door. Figure 33.2.
6. To install the fi ber board baffl e, repeat steps 2 through 4 in
reverse. Be sure the fi ber board baffl e and ceramic blanket
are fully pushed back into position and the blanket is down
fl at. The front of the blanket should be fl ush with the front of
the baffl e.
Push baffle board up slightly to
allow room to turn the handle
Figure 33.1
Ceramic Blanket
Figure 33.2
October 13, 2015
R
Baffle Board
Baffle Board
7004-187L
Yosemite Wood Stove
Page 33