Remote Control - Convair Supercool Instruction Manual

Signal
transmission point
Display area
Swing button
Fan speed
adjust button
Timer button
Hour button
Preparation before operation
Step 1: Remove the battery cover and insert
new batteries (AAA), making sure the + and -
match the compartment markings (Fig 10)
Step 2: The remote display will alternately
flash "COOL" or "HEAT".
operating mode to match your cooler type.
by p ressing the MODE button when the
correct setting is displayed.
Select "COOL" for Supercool NR, TRB or FR
!
Select "HEAT" for Supercool TRC
!
To change the setting, remove the batteries
and press the "ON/OFF" button, then repeat
steps 1 and 2.
Your remote control is now ready for use
During Operation
If the display disappears, or the remote
control will not operate the air conditioner, the
batteries may need to be replaced.
If there is no display, or only part display,
remove the batteries and repeat steps 1 and
2 above. If this does not solve the problem
and the batteries have been replaced,
contact your nearest service centre for
advice.
Note! The Supercool must be plugged in and
switched on for the remote control to operate
the air conditioner. To use, point at the signal
NOTE:
!
WASTE BATTERIES SHOULD
BE DISPOSED OF CORRECTLY

REMOTE CONTROL

9
Temperature
increase/decrease
buttons
On/Off button
Mode button
Hold button
Minute button
Clock button
receiving window on the control panel and
press the remote button. The air conditioner
will "beep" when a signal has been received.
. If there is no beep, press the remote button
again, ensuring it is within range (6 metres) of
Select the
the air conditioner.
If there are two of the same air conditioners
installed, they cannot be controlled
separately. When you operate either
remote, it will turn on both air conditioners if
they are both within signal range (6 metres).
Care of your remote control
Don't let the remote control drop onto hard
surfaces or be subjected to sudden shocks
in any way. The warranty does not cover
misuse or accidental damage.
Don't place the remote control in direct
sunlight, or near extremes of temperature.
This will affect the control's temperature
reading.
Don't allow the remote control to get wet.
Don't place near strong electromagnetic
waves.
Don't mix old and new batteries ! If the
remote control will not be used for a long
time, remove the batteries to avoid
corrosion.
6
10
Battery
compartment
Battery cover