Mantis 7990 Operator's & Parts Manual page 8

Assembly
LET'S BEGIN
• With the box upright, open the box and remove insert.
• Remove second cardboard insert and all loose parts
that are at the top of the tillers cradle.
• Lay the box on the side and open the bottom flaps.
• Return the box to an upright position and pull the box
straight up.
• Right throttle handle attached to tiller assembly with
installed tines will be in the box cradle.
• Lay everything out so you can easily identify the parts
(see parts image and list on page 6).
LOWER HANDLE ASSEMBLY
1
• For ease of assembly and stability it
is important that you keep the engine
assembly in its cardboard cradle.
4
• Line up the holes of the right loop
handle with the holes of the lower
right handle.
• Slide the two 3.25" bolts through
the hole.
8
2
• Open cradle by pulling sides apart.
5
• Position this assembly onto the
recessed channels below the engine.
Operator's Manual
3
• Slide the foam grip onto the right
loop handle.
6
• Slide the lower left handle onto
the bolts.